To API or not

Worked a bit on the processing sketch to get data decoded. I noticed that the serial data sent from the router was broken up. I would get a ‘1’ and then ’23’. I believe that this will be resolved with the API setting on the router. I was able to ensure that the remote addressing was correct.

I was able to get the router running off the USB connecter used for programming. This is useful and should be helpful in the future when remote uploading.

Next step is to use the ATDB to get RSSI data for the last RF packet. I also need to build up another router to test with a bigger network (after getting the router to run under API). Also need to properly decode the ATND result. That will take a little work.

Leave a Reply

Your email address will not be published. Required fields are marked *